Rigging the TerrorEyz |
|
1. Poke a hole in the top of the lure (the flat side is the top) in the middle towards the rear of the eye socket. Remove the hook point from the hole you just made. This hole is where the eye of the hook will come out later in the rigging process. 2. You will see there is a ¼" channel that runs inside the lure from the opening on top of the lure to the back of the eye socket. Push the round part of the hook into the channel at the back of the eye socket. Keep pushing until the point of the hook comes out the opening on the top of the lure. 3. Hold the hook between your thumb and forefinger and rotate the lead head into the eye socket allowing the eye on the hook to come out the hole you made in step one. 4 & 5. Stretch the front of the lure out over the small pin (gently don't tear the lure) in the front of the lead head, center the pin. Make sure the hook eye is through the hole you made in step 1. 6. Push the lure on the pin. That's it you are ready to start fishing. Use a loop knot for best results.
|
|
1253 S. E. Dixie Cutoff Road |
Designed, Hosted & Maintained
by |
